Description
| NOZZLE width (mm) | Maximum Groove Width (mm) |
|---|---|
| 13 | 8 |
| 19 | 11 |
| 25 | 12 |
AGNM (Gouging) Nozzle for NM 400
Hard drawn Tellurium copper used in one-piece nozzles
- withstands heat & wear
- out lasts any copper nozzles
One piece nozzle has swaged interior
- Gas passages are mirror smooth with internal angles rounded
- Non-turbulent more efficient gas flow.
- Clean smooth cuts with minimal kerf loss
Preheat ports are closely spaced around cutting orifice
- For greater concentration of preheat flames.
Long parallel preheat passages
- Permit redressing of the nozzle without affecting performance
Related products
-
NM 250 CUTTING BLOWPIPE
NM 250 is a well-balanced Nozzle Mix hand cutting Torch. The Torch gives more Safety and Efficiency than Injector Mix. Light weight NM cutters are easy to handle and can withstand rough usage for long time. The Torch is suitable with Oxy/Acetylene or Oxy/LP Gas and cutting capacity up to 300 mm.
-
PNM (LPG) Nozzle for NM 250/ NM400
Hard drawn Tellurium copper used in one-piece nozzles
- withstands heat & wear
- out lasts any copper nozzles
One piece nozzle has swaged interior
- Gas passages are mirror smooth with internal angles rounded
- Non-turbulent more efficient gas flow.
- Clean smooth cuts with minimal kerf loss
Preheat ports are closely spaced around cutting orifice
- For greater concentration of preheat flames.
Long parallel preheat passages
- Permit redressing of the nozzle without affecting performance
-
A-Type (Acetylene) Nozzle for Cutogen 5
Hard drawn Tellurium copper used in one-piece nozzles
- withstands heat & wear
- out lasts any copper nozzles
One piece nozzle has swaged interior
- Gas passages are mirror smooth with internal angles rounded
- Non-turbulent more efficient gas flow.
- Clean smooth cuts with minimal kerf loss
Preheat ports are closely spaced around cutting orifice
- For greater concentration of preheat flames.
Long parallel preheat passages
- Permit redressing of the nozzle without affecting performance
-
Single Stage Argon Flowmeter Regulator
This is a single-stage flowmeter regulator, which provides precise regulation and measurement of gas flow. This is well suited for a wide variety of industrial uses.
- Service Pressure: 200 bar
- Rated flow: 25 lit/min.
- Inlet connection : Thread EXT-5/8″ BSP RH.
- Outlet connection : Thread EXT-318″ BSP RH.
- Preset Type: Provides accurate control of gas pressure to the flowmeter.
- Imported safety pressure gauges designed for 250 bar pressure, confirming to ISO 5171 standards.
- Body: Chrome plated
Reviews
There are no reviews yet.